Hot

Hardware Connection

If you don't know how to connect the equipment?

Two ports are parallel ports, you can select anyone to connect the middle machine and the lower machine in series.

You can also select any ports to connect the two lower machines.

If there is only one middle machine, you can connect the middle machine's network port and computer's network port.

If thers are many middle machines, the network cable connected to the network port of the switch or the LAN port of the router, which inserts into the network port of the middle machine.
If you don't know how to use clamps?

Clamp wires have positive and negative wire code tubes, which can be wired according to V +, I +, V -, I -.
The middle machine can be connected, but the lower machine can not be connected.

The middle machine can be connected, but the lower machine can not be connected.
How to modify the repeated equipment number about 3008/ 4008 series?

Use our calibration software to complete the chamber number modification.
If you find there's no channel display on software, when you connect the new equipment with the previous equipment in the same series. What should you do?

You need to search the new equipment through the middle machine again and remap it once.
After automatic disconnection, you find it automatic connection again.

Check whether the network connection is normal which is not only between the computer and the switch but also between each equipments.
If ther are 10 equipments mapping, there are only 8 equipments display.

The client defaults to 1*8 mapping mode. You can select 1*16 to change the client configuration file.
You are prompted IP conflict or IP occupied when you set IP.

You can set IP address via the key and watch it on LCD screen.